This video shows Strips Comfort, but this process is standard for all Strips
If you have lost connection to the gateway or the controller and need to reset the device to factory settings, follow these instructions
- Take the magnet, move it to the rounded edge and wait for the blink. Then move the magnet away
- Move magnet to the rounded edge once again and wait for the blink
- Move magnet to the rounded edge one last time, but keep it there for 10 seconds
- If successful = 1 short blink followed by a long blink a few seconds later. If you’re using the LoRaWAN version of Strips, there will be an additional long blink
- If fail = 0 LED blinks
