Designed to disappear. Built to last.
Ultra-low-power LoRaWAN and Z-Wave sensors for buildings, cities and industry. Five form factors on three platforms, small enough to blend in anywhere and built to run for years on a single battery. Each product states its own battery life.
Five form factors. Three platforms.
Strips comes on two radios: Z-Wave for the smart home, LoRaWAN for buildings and cities. Square, Square Xtreme, Puck and Prism share a third: one LoRaWAN hardware architecture and firmware, configured by NFC and extended with downloadable VSM apps.
Find the right sensor
What do you need to know? Pick it, and the sensors that do it appear.
Tick what the sensor must have, and the list shows the sensors with everything you tick. For IP rating, pick the lowest you need.
No sensor has all of those functions in one device. Untick one, or ask us: a combination of two sensors in Yggio usually does it.
What every sensor shares
Years on one battery
Ultra-low-power design, and cloud-side processing where it saves energy. Battery life depends on the sensor and how often it reports: well over ten years for most sensors.
Configured over the air
Every sensor takes its settings over the air, so a change of reporting interval or threshold never means a ladder. Square, Square Xtreme, Puck and Prism can also be set up on site with an Android phone over NFC, and they run downloadable VSM apps: a sensor already on the wall can be given a new task without touching the hardware.
Quality you can trace
SIDD (Sensative In-Device Diagnostics) keeps an internal quality record in every sensor. On Square, Square Xtreme, Puck and Prism it is collected automatically at each NFC read; Strips are read out physically. That gives traceability for a whole fleet instead of a sample.
Works on any network. Better with Yggio.
Every sensor runs stand-alone on any compatible LoRaWAN or Z-Wave network. Add Yggio and it becomes part of one governed operational layer, next to the rest of your devices and systems.
Accessories
Mounting and add-ons for the sensors above.
Strips +Switch
A sliding button that clips onto any Strips for LoRaWAN. Slide it to order a service, start a scene or switch a device, and the sensor becomes an actuator too.
Fits: Strips for LoRaWAN
DetailsStrips +Clip
A mounting clip for Strips: holds the sensor close to rough surfaces such as concrete, brick or untreated wood where adhesive will not stick, and lets you move it without leaving a trace.
Fits: Strips for LoRaWAN, Strips for Z-Wave
DetailsSquare screw mounting kit
Two adhesive plates for mounting any Square sensor with screws where adhesive is not enough, behind the device or beside it.
Fits: Square
DetailsPuck mounting plates
A thin steel plate that Puck is glued to. Screw it to a wall or strap it to a pipe with cable ties. Sold separately.
Fits: Puck
Details










