Overview
Strips Comfort measures temperature to ±0.2 °C, relative humidity to ±1.8 % and ambient light in lux, and reports them over LoRaWAN. It fixes with adhesive backing and, at under 3 mm, disappears along a skirting board, a door architrave or a window frame.
Use it to keep an office comfortable, to watch for damp in cellars and attics, or to feed a heating and ventilation system with the room data it needs. A magnet sensor is built in for the +Switch accessory, a slider with small magnets that turns the strip into a button for ordering a service or starting a scenario. IP63, for indoor and sheltered outdoor use.
Specifications
- Sensors
- Temperature, humidity, ambient light (lux), magnet sensor for +Switch
- Temperature accuracy
- ±0.2 °C
- Humidity accuracy
- ±1.8 % RH
- Protocol
- LoRaWAN 1.0.4, Class A, OTAA
- Frequency
- EU868 · US915 · AU915 · AS923 · KR920 · IN865 · JP920
- Battery
- Built-in LiMnO₂, 480 mAh, 10+ years
- Radio range
- Up to 10 km line of sight
- IP rating
- IP63
- Operating temp
- –20 to +60 °C
- Dimensions
- 195 × 15 × 3 mm
- Weight
- 11 g
- Mounting
- Adhesive backing; +Clip for rough or temporary surfaces
- Patent
- Granted: SE 537 509 · EP 3053152 · EP 3937144 · US 9,953,496 · US 10,720,033 · US 11,170,617
- Also available as
- Strips Comfort 800 for Z-Wave
Key features
- ✓Accurate where it matters: ±0.2 °C and ±1.8 % RH, accurate enough to control heating and ventilation as well as to log.
- ✓Blend-in design: Under 3 mm and adhesive-mounted, it disappears along a skirting board, a door architrave or a window frame.
- ✓Add a button with +Switch: The built-in magnet sensor reads the +Switch slider accessory, so the same strip can order cleaning or set a scene.
- ✓Over ten years, no maintenance: Deploy it across a whole building and leave it there: the battery lasts over ten years.
Accessories
- Strips +Switch: A sliding button that clips onto any Strips for LoRaWAN. Slide it to order a service, start a scene or switch a device, and the sensor becomes an actuator too. Details
- Strips +Clip: A mounting clip for Strips: holds the sensor close to rough surfaces such as concrete, brick or untreated wood where adhesive will not stick, and lets you move it without leaving a trace. Details