Square screw mounting kit
Two 2 mm adhesive plates that let any Square sensor be fixed with screws, hidden behind the device or beside it.
Overview
The kit consists of two 2 mm plates with adhesive on both sides. Screw the plates to the wall, then press Square onto them. The plates come attached to a foil that marks the drill points, with arrows showing which holes to use for screws behind the sensor and which for screws beside it.
For an invisible fixing, place the plates so the screws sit behind the device and use ultra-low-profile flat-head screws. Mark and drill, screw the plates on with the thick adhesive side towards you, peel the protective films from plate and device, check the alignment and press the sensor firmly onto the plates. To remove a device mounted with adhesive, slide dental floss behind it and saw gently through the adhesive.
Specifications
- Works with
- Every Square sensor: Comfort, Sound, Air, CO2, Presence, Tracker
- Contents
- 2 × 2 mm adhesive plates on a marking foil
- Screw positions
- Behind the device (invisible, ultra-low-profile flat-head screws) or beside it
- Removal
- Dental floss through the adhesive
Key features
- ✓Invisible or visible: Screws behind the device with low-profile heads, or beside it when access matters.
- ✓Drill points marked: The foil the plates arrive on doubles as the drilling template.
- ✓Adhesive stays on the plates: The sensor presses onto the plates, so the wall takes the screws and the device keeps its clean back.
- ✓Comes off cleanly: Dental floss behind the sensor cuts the adhesive without damage.