*NOTE : This process is only for units just taken out of the box with the magnets still attached to the unit, if you have removed the magnets and did not see Strips added to your gateway, please try Manual Inclusion.
How to add strips Drip using the auto-add mode to your Z-Wave controller
- Set your controller to “Add-mode”
- Remove the magnet and place Strips on a flat surface
- 1 Short LED blink indicates auto-add has been initiated
- 3 Long LED blinks = Success!
- 5 Short blinks = Fail (Try manual-add)
Was this helpful?
Let us know if you liked the post. That’s the only way we can improve.
